NSX CLI Guide

get gateway <uuid> bgp neighbor <ip-address>

Display information about a specific BGP neighbor.

Parameters:

Option	Description
<uuid>	Datapath UUID argument
<ip-address>	Network IP address argument

Example:

nsx-edge-1> get gateway 3a57c438-7ee9-4ba2-92ef-6f758931e1be bgp neighbor 2005::2828:280a BGP neighbor is 2005::2828:280a, remote AS 1000, local AS 2000, external link Administratively shut down BGP version 4, remote router ID 0.0.0.0, local router ID 50.50.50.1 BGP state = Idle Last read 2d16h06m, Last write never Hold time is 180, keepalive interval is 60 seconds Configured hold time is 4, keepalive interval is 1 seconds Message statistics: Inq depth is 0 Outq depth is 0 Sent Rcvd Opens: 0 0 Notifications: 0 0 Updates: 0 0 Keepalives: 0 0 Route Refresh: 0 0 Capability: 0 0 Total: 0 0 Minimum time between advertisement runs is 0 seconds For address family: IPv6 Unicast Not part of any update group Community attribute sent to this neighbor(all) 0 accepted prefixes Connections established 0; dropped 0 Last reset never BGP Connect Retry Timer in Seconds: 120 Read thread: off Write thread: off BFD Status: Not configured

Mode:

Basic

Availability:

• Autonomous Edge
• Edge