NSX CLI Document

get ens fpo stats <lcoreID-or-uplink-arg>

Get FPO stats for a datapath with lcore ID or uplink

Parameters:

Option Description
<lcoreID-or-uplink> Lcore ID or Uplink


Example:

esx-1> get ens fpo stats vmnic1 FPO Call Ring Full : 0 Flow Creation Ring Full : 0 Flow Destroy Ring Full : 0 Flow Update Ring Full : 0 FPO Call Session Mismatch : 0 Device Capacity Exceeded : 0 Succeeded Flow Validations : 0 Succeeded Flow Creations : 0 Succeeded Flow Destroys : 0 Succeeded Flow Queries : 0 Succeeded Flow Flushes : 0 Failed Flow Validations : 0 Failed Flow Creations : 0 Failed Flow Destroys : 0 Failed Flow Queries : 0 Failed Flow Flushes : 0 Pending FPO Flows : 0 Succeeded Bulk Res Allocs : 0 Succeeded Bulk Res Frees : 0 Succeeded Bulk Res Queries : 0 Succeeded Bulk Res Sets : 0 Succeeded Bulk Res Resets : 0 Failed Bulk Res Allocs : 0 Failed Bulk Res Frees : 0 Failed Bulk Res Queries : 0 Failed Bulk Res Sets : 0 Failed Bulk Res Resets : 0 Succeeded CT Creates : 0 Succeeded CT Destroys : 0 Succeeded CT Modifies : 0 Succeeded CT Queries : 0 Failed CT Creates : 0 Failed CT Destroys : 0 Failed CT Modifies : 0 Failed CT Queries : 0 FPO Uplink Enable Calls : 1 FPO Uplink Disable Calls : 0 FPO Calls in Disabled State : 0 esx-1>

Mode:

Basic

Availability: